"The Finger Saver" Rod End Tool

This product is manufactured by us in house using 3D printing. It’s important to understand that 3D printing builds objects layer by layer, which can lead to some inherent characteristics that differ from traditional manufacturing methods:

• Layer Lines: You may observe subtle horizontal lines on the surface of your parts, particularly noticeable on curved or angled surfaces. These are a natural result of the layered printing process.
• Minor Surface Imperfections: Occasionally, small variations in surface texture, sometimes referred to as 'blobs' or 'zits,' may appear. These are often a result of nozzle start/stop points or other minor variations during the printing process. Some part of the parts may have a textured finish on them due to the texture of the 3D print bed itself.
• Support Marks: If the part required any support structures to print correctly, since you cannot print in thin air, their removal can sometimes leave slight marks or rough areas on the surfaces where they were attached. We try to minimize these, and use them only in areas not highly visible.